![]() Otherwise you wait 600 seconds and the FortiGate reverts the change. If you have done your change and your are happy, type execute cfg saveĪnd everything is fine. The timeout specifies the timeframe in seconds in which you have to save the configuration manually, otherwise it is reverted. When you press enter, you realise you made a typo and the firewall is not reachable anymore.īefore you do now dangerous modifications, change the behaviour of the FortiGate. Now you have to save the configuration manually in a specified time frame, otherwise the change is reverted.Įxample: You change the default gateway. ![]() It is possible on the FortiGate to change it to “Config Save Revert”. If you configure something on your FortiGate which disables the connectivity from you to your firewall, this behaviour is bad. ![]() and I will also show you the configuration from the Aruba switch as well so. On the CLI the config becomes active and is saved when you leave a config block by typing next or end. FortiGate firewall is capable of running 802.1q tagging on its interfaces. By default, a FortiGate does autosave the configuration, every time you press Apply or OK in the GUI.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |